Hi,

Total newb question here so I apologize in advance :)

I'm just looking at getting brand new rims and tires and was looking at this set...

Ebay Link (http://cgi.ebay.com/ebaymotors/18-10-9-Black-Mustang-Bullet-wheels-tires-DEEP-DISH_W0QQcmdZViewItemQQcategoryZ66484QQihZ019QQite mZ290078741583QQrdZ1)

Will it fit properly? I realize it's for a mustang, but the bolt pattern is the same.

The offset is 25mm on the front and 29mm on the rear. I'm rebuilding the RX8 with my dad (who's the mechanic) after a writeoff, not mine.

Cheers

i think u will have problems with the offset........... it seems too small especially for 18x10

and not sure is the PCD the same for mustang and rx8 ?

if you stretch the tires and run some serious neg camber it could work, but even then its not really streetable

just roll the fender and put about -3 camber will work no problem!

...I'm just looking at getting brand new rims and tires and was looking at this set...I realize it's for a mustang...
:nono:
http://oewheels.net/oe-3448-b-10-j-265-p-2-new.jpg
:slap:

http://www.1010tires.com/WheelOffsetCalculator.asp

do the math..

beers :beer: